Yard Works YW1100TP Instruction Manual page 12

Priming
Priming the pump prepares the motor for safe operation.
1. Ensure the pump is turned off at the mains power.
2. Remove the plastic protection cover from the discharge outlet (2) pump
housing (Fig. 6).
3. Using a hose, fill the pump by pouring water into the discharge outlet (2).
Ensure the pump and suction line are full (Fig. 7).
Discharge Outlet
Connecting Hose or Pipe to the Discharge Outlet
Note: Teflon tape (not included) is required on threads to ensure a water tight seal and prevent any leakage.
1. Screw a 25.4mm (1'') male threaded hose adaptor (not included) into the
discharge outlet (2). Securely attach the output hose or pipe to the other end
of the 25.4mm (1'') male threaded hose adaptor (not included) (Fig. 8). Ensure
you have the correct diameter of hose or pipe that is compatible with your
water discharge application.
Note: The discharge hose or pipe you are using must have a minimum diameter of
19mm ( / ").
3
4
Note: Ensure the discharge hose or pipe is not restricted in any way and no pressure is obstructing the hose or
pipe when the pump is in operation.
SET-UP & INSTALLATION (cont.)
11
Fig. 6
Fig. 7
Fig. 8