AT&T E5911 User Manual page 25

>
DIRECTORY
CALL LOG
>
DIAL TYPE
DIRECTORY
DIAL TYPE
TONE
Telephone operation
Handset settings
Dial type
Using this function, you can choose TONE or PULSE
(rotary) dialing. The factory default setting is TONE.
Change this to PULSE only if you do not have
touch-tone dialing service.
1. Press MENU/
feature menu.
2. Use the up or down NavKey
to the DIAL TYPE menu, press
enter the menu when it is highlighted with a >
symbol.
3. Press the up or down NavKey
TONE or PULSE.
/SELECT to save your preference.
4. Press
MENU
NOTE: If you have more than one handset registered, dial
type change made on any one handset will apply to all.
Temporary ring silencing
Press OFF/
CLEAR
ephone is ringing to silence the ringer temporarily.
This will silence the ringer without disconnecting
the call. The next incoming call will ring normally
at the pre-set volume.
NOTE: If there is more than one handset in use, all hand-
sets ring with an incoming call except those with the vol-
ume turned off. Press
one handset will only silence the ringer of that particular
handset but the other handset(s) will continue to ring.
22
in idle mode to enter the
SELECT
or MUTE/
DELETE
OFF/
CLEAR
or to scroll
/SELECT to
MENU
or to select
while the tel-
or MUTE/ on
DELETE