Electrical Connection - Hotpoint SE103PGX Operating Instructions Manual

Electrical Connection

Electrical connection
The electrical connection to the mains must be made
on the appliance. The power voltage and frequency
are as indicated on the rating plate.
THIS APPLIANCE MUST BE EARTHED. THIS APPLIANCE MUST BE EARTHED.
! THIS APPLIANCE MUST BE EARTHED. THIS APPLIANCE MUST BE EARTHED. THIS APPLIANCE MUST BE EARTHED.
Connecting the power supply cable
To open the terminal board:
• Using a screwdriver, press on the tabs situated
on each side of the terminal board cover.
• Pull open the terminal board cover.
To connect the power supply cable, proceed as
follows:
• • • • • Unscrew the cable clamp screw and the contact
screws L-N-.
• Fasten the wires beneath the screwheads using
the following colour scheme: Blue (N) Brown (L)
Yellow-Green 
• Fasten the power supply cable in the
corresponding cable clamp and close the cover.
Electrical Connection:
4 2
N L
You can connect your oven to the system means of
a terminal board. Refer to above information for the
minimal cable sections and the calibration of the
protective elements according to the connection.
If the appliance is installed with a junction box, an
omnipolar circuit breaker - with a minimum contact
opening of 3mm - should be installed between the
appliance and the mains.
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
Voltage Frequency:
220-240V~1+N 50/60Hz
Fuse Section: 16A
Supply cable:
3x1.5mm
2
Power cable supply connection to the electrical
mains:
We recommend you use a power supply cable which
is long enough to allow you to take the oven out of
its recess in the event of maintenance operations
(only use HAR - H 05 - RRF quality cables fitted with
a plug conforming to the regulations in force.
The plug must be accessible at all times.
Unplug the appliance before all operations, even
when replacing the oven lamp.
Using the appliance without correct earthing is
highly dangerous.
! After connecting the appliance to the flexible
cable, tighten all the screws on the terminal
board.
! The cable must be checked regularly and
replaced by authorised technicians only ( see
Assistance ).
TABLE OF CHARACTERISTICS
width 43.5 cm
height 32 cm
Dimensions
depth 40 cm
56 l
Volume
voltage: 220-240V ~ 50/60Hz
Electrical
maximum power absorbed
connections
2800 W
Directive 2002/40/EC on the
label of electric ovens.
Regulation EN 50304
ENERGY LABEL
Declared energy
consumption for Forced
convection Class
– heating mode:
This appliance conforms to
the following European
Economic Community
directives: 2006/95/EEC
dated 12/12/06 (Low
Voltage) and subsequent
amendments –
2004/108/EEC dated
15/12/04 (Electromagnetic
Compatibility) and
subsequent amendments -
93/68/EEC dated 22/07/93
and subsequent
amendments.
2002/96/EEC and
subsequent amendments.
1275/2008 stand-by/off
mode.
GB
Gratin
3