Care And Maintenance; Switching The Appliance Off; Cleaning The Appliance; Cleaning The Oven Door - Hotpoint SE103PGX Operating Instructions Manual

Care and maintenance

Switching the appliance off

Disconnect your appliance from the electricity supply
before carrying out any work on it.

Cleaning the appliance

• The stainless-steel or enamel-coated external parts
and the rubber seals may be cleaned using a
sponge that has been soaked in lukewarm water
and neutral soap. Use specialised products for the
removal of stubborn stains. After cleaning, rinse and
dry thoroughly. Do not use abrasive powders or
corrosive substances.
• The inside of the oven should ideally be cleaned
after each use, while it is still lukewarm. Use hot
water and detergent, then rinse well and dry with a
soft cloth. Do not use abrasive products.
• All accessories can be washed like everyday
crockery, and are even dishwasher safe.
• We recommend that detergents are not sprayed
directly onto the control panel, but that a sponge is
used instead.
! Never use steam cleaners or pressure cleaners on
the appliance.

Cleaning the oven door

Clean the glass part of the oven door using a sponge
and a non-abrasive cleaning product, then dry
thoroughly with a soft cloth. Do not use rough abrasive
material or sharp metal scrapers as these could
F
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
scratch the surface and cause
the glass to crack. For more
thorough cleaning purposes,
the oven door may be
removed:
1. Open the oven door fully
( see diagram ).
2. Lift up and turn the small
levers located on the two
hinges ( see diagram ).
2. Use a screwdriver to lift up
and turn the small levers F F F F F
located on the two hinges ( see
diagram ).
3. Grip the door on the two
external sides and close it
approximately half way. Pull
the door towards you, lifting it
out of its slot ( see diagram ).
3. Grip the door on the two
external sides and close it
approximately half way.
Unlock the door by pressing
on the clamps F F F F F , then pull the
F
door towards you lifting it out
of its seat ( see diagram ).
To replace the door, reverse this sequence.
Inspecting the seals
Check the door seals around the oven regularly. If the
seals are damaged, please contact your nearest After-
sales Service Centre ( see Assistance ). We recommend
that the oven is not used until the seals have been
replaced.

Replacing the light bulb

Oven
compartment
Lamp
Seal
Glass door
1. Remove the glass cover using a screwdriver.
2. Remove the light bulb and replace it with a similar
one: Wattage 15 W, cap E 14.
Replace the glass cover, making sure the seal is
positioned correctly ( see diagram ).
GB
To replace the
oven light bulb:
11