Control Panel
To place the control panel in the service position,
remove 4 torx screws from the top of the
backsplash and rotate the top forward.
Electronic Control Board
The electronic control board is attached to the
back of the control panel.
Note: If motor does not operate, perform Motor
Does Not Operate Diagnostic before replacing
electronic control board.
To remove the electronic control board:
1. Place the control panel in service position.
2. Disconnect the harness connections.
Remove and retain the model selector harness
plug for reassembly.
3. Remove 2 (1/4-in.) screws from the control
board.
Caution: To prevent electrostatic discharge,
ground yourself to the washer cabinet or use an
ESD wristband.
4. Remove the electronic control board by gently
lifting from position.
Note: When reassembling, align the LEDs with
the appropriate control panel indicators.
CN5
CN6
CN7
Washer Components
CN4
CN3
Remove 4 Screws
Model
Selector
Harness
Remove Harness
Connections
CN2
– 13 –
GEA00371
Electronic
Control Board
Remove Harness
Screws
Connections
GEA00373
CN1
P0003552