IdeaItalia BTCK100NEW User Manual page 10

4. Charging your Bluetooth speakerphone
The Bluetooth headset comes with a built-in rechargeable battery. Prior to using
the headset, it is recommendable to charge the battery fully for the first time.
Normal fully charger time is 3 hours. Connect the charger to an AC wall outlet
and the charge plug to Speakerphone charging socket.
After completion of charge, please remove the chargers from headset and outlet.
Charging indication will be delayed for a few minutes if the Speakerphone
has not been used for a long time or the battery is drained.
When battery becomes low, LED will flash red every 3 seconds, speaker eve
ry one minute 3 beeps. Please recharge the battery as described above. To
prolong durability of battery, it's recommended to charge the Speakerpho
ne whenever low battery is encountered. Under low battery condition, if he
adset is continuously used, it'll decrease durability of battery, as well as stan
dby time, and cause longer charge time than normal 3 hours.
The red LED will flash on while charging and flash off when charging is com
pleted.
5. Turning ON/OFF the Speakerphone
Power On: when speakerphone is under off mode, press and hold the "MFB"
for 4 seconds until you hear a short beep. The blue LED will flash 5ti mes, and
then the speakerphone will automatically connect to the last connected mobile
phone.
Power Off: speakerphone is under standby mode, press and hold the "MFB"
button for 4 seconds until you hear a short beep. The red LED will flash 5
times before power off.
- 10 -