Advertisement
Available languages
Available languages
N.B.
When the speakerphone is in Multipoint mode and connect with only 1
mobile phone, it can also enter voice dial function by press "V+" button
once, or make last outgoing number re-dialing by press "V+" button twice.
The Multipoint speakerphone can be paired with 2 mobile phones at the
same time. When one of them receives an incoming call, the other phone
will be disconnected from speakerphone but resume connection
automatically after the first one has finished the phone call..
11. Low voltage protection of battery
When the voltage of battery decreased to 3.3V, the red LED will flash in every
3 seconds, and the speakerphone will be power off automatically when the
voltage under 3.0V.
12. Restore to default setting
Please follow the steps below to reset the speakerphone to its original setting
and remove all the previous pairing and connection.
Ensure the speakerphone is under standby mode.
Press and hold both of "V+" and "V-" buttons for 10 seconds until the blue
and red LED flash 5 times, then the speakerphone will resume standby
mode. The speakerphone is now back to original setting, and after power
on the speakerphone again, it will enter pairing mode automatically.
N.B. If the speakerphone is connected with a mobile phone before restore
to default setting, it will enter pairing mode automatically after restored to
default. If the speakerphone is not connected with the mobile phone before
restore to default setting, it will be under standby mode after restored to
default setting.
- 14 -
Advertisement
