Advertisement
A
ssembly
1) Remove all parts from shipping carton (see cover).
2) Use nonmetallic washers (between round search coil and clevis fiber
rod) and fiber bolt and thumbnut to secure search coil to fiber rod.
3) Insert fiber rod into curved rod, line up buttons into one of adjust-
ment holes.
4) Unravel search coil cable and wind around rods (first revolution over
top of rod). Plug search coil cable into control box, screw "finger-tight"
to secure.
5) Grip by handle, with arm in elbow cup and sweep search coil over
floor. If necessary, for comfort, compress buttons and reposition fiber
rod. If necessary, Elbow Cup is also adjustable for comfort.
s
eArching
1) Open battery door by pressing elongated button on back of display
and flipping open door. Install two nine volt alkaline batteries (according
to +/- position shown inside door). Close door.
2) Press ON/OFF button. Sweep search coil over ground evenly (near
to or touching ground surface) keeping close to the ground throughout
each sweep and overlapping each pass as if mopping a floor.
3) Solid repeatable beeps and repeatable display signifies a "hit".
Press P/P button and "X" areas to pinpoint exactly where to dig. Press
P/P again to continue searching.
4) Broken or inconsistent beeps and display indicates undesirable
metals.
For more information on
White's Detectors -
®
www.whiteselectronics.com
Advertisement
