Controls & Features - Cub Cadet 10M Operator's Manual

Controls and Features
Blade Control
The blade control is attached to the upper handle of the mower.
Depress and squeeze it against the upper handle to operate the
unit. Release it to stop engine and blade.
WARNING:
Never attempt to bypass its operations.
Cutting Height Adjustment Levers
One adjustment lever is located on each wheel and is used to
adjust the cutting height. All four levers have to be at the same
relative position to ensure a uniform cut.
Mulch Plug
The mulch plug is used for mulching purposes. This process
recirculates the clippings back to the lawn. Do not operate the
mower if the mulching plug is not firmly situated on the unit.
12
Recoil Starter
Side Discharge
Chute
This blade control is a safety device.
Blade Control
Choke Control
Mulch Plug
Figure 4-1
Side Discharge Chute
Your mower is shipped as a mulcher. To discharge the grass
clippings to the side instead, follow the instructions in the
Assembly & Set-Up section to attach the side discharge chute.
WARNING:
chute area on cutting deck. Refer to warning label
on the unit.
Choke Control
The choke control is located on the left side of the handle and
when activated, closes the choke plate on the carburetor and
aids in starting the engine. Pull the choke control to activate the
choke on the engine. Use of the choke may not be necessary if
the engine is warm or the air temperature is high.
Recoil Starter
The recoil starter is attached to the right upper handle. Stand
behind the unit and pull the recoil starter rope to start the unit.
Cutting Height
Adjustment
Lever (one at
each wheel)
Keep hands and feet away from the
4