Advertisement
Please note that some of the contact details on
this PDF document may not be current.
Please use the following details if you need to
Email: customer.services@gdcgroup.co.uk
The customer support section of our website also features a wide
range of information which may be of use to you and is available
24 hours a day. It includes:
• Operating and installation instructions
• Easy 'How to use' guides for storage heaters
• Service and repairs
• Where to buy our products
• Literature downloads
• Heating requirement calculator
Visit ‐ www.dimplex.co.uk/support
A division of GDC Group Ltd
Millbrook House Grange Drive Hedge End Southampton SO30 2DF
www.dimplex.co.uk
Contact Details
contact us:
Telephone: 0844 879 3588
Registered No: 1313016 England
VAT GB 287 1315 50004
EEE Producer Registration Number –
WEE/GE0057TS
Paper from sustainable sources
Advertisement
Table of Contents
Related Manuals for Dimplex XMC712N
Summary of Contents for Dimplex XMC712N
- Page 1 • Easy ‘How to use’ guides for storage heaters • Service and repairs • Where to buy our products • Literature downloads • Heating requirement calculator Visit ‐ www.dimplex.co.uk/support A division of GDC Group Ltd Registered No: 1313016 England VAT GB 287 1315 50004 Millbrook House Grange Drive Hedge End Southampton SO30 2DF EEE Producer Registration Number –...
- Page 2 85150 XMC(N) COMBINED STORAGE AND CONVECTOR HEATER MODELS: XMC712N 1.7kW/12kWh Storage and 1kW Convector XMC718N 2.55kW/18kWh Storage and 1.5kW Convector XMC724N 3.4kW/24kWh Storage and 2kW Convector INSTALLATION OPERATING INSTRUCTIONS IMPORTANT PLEASE READ THIS LEAFLET CAREFULLY AND RETAIN FOR FURTHER USE.
-
Page 3: Installation Instructions
INSTALLATION INSTRUCTIONS Place the heater on its feet and in the desired position PREPARATION against the wall. Ensure the heater is based on a fi rm level surface at least 75mm from any end wall and at least The heater will arrive Model 712N - 8 bricks 250mm below any shelf or similar projection. - Page 4 Fit the front layer of bricks again with the recess towards the element. The complete core will comprise: 712N - 2 x 4 Brick Columns 718N - 3 x 4 Brick Columns 724N - 4 x 4 Brick Columns Replace the inner front complete with insulation by locating its bottom edge behind the front lip of the chassis and inserting retaining screws along the top and both sides.
-
Page 5: Control Function
CONTROL FUNCTIONS Initially set the input to 4. If the heater does not maintain a satisfactory room www.dimplex.co.uk where you will fi nd our self help guide temperature the following day this setting should be increased. Conversely by clicking on ‘After Sales’ or ring our help desk on 0845 if the room temperature is too high this setting should be reduced.
Need help?
Do you have a question about the XMC712N and is the answer not in the manual?
Questions and answers