How To Connect The Inlet Hose - Daewoo DWF-312W Service Manual

§• §•

How to Connect the Inlet Hose

Be careful not to mistake in supplying between the hot(maximum : 50 C) and cold water.
In using only one water tap or in case of attached one water inlet valve, connect the inlet hose to the cold water inlet
valve.
Do not over tighten : this could cause damage to couplings.
FOR ORDINARY TAP
Pull down the collar
1
of the inlet hose to
separate it from the
water tap adapter.
Remove the tape,
4
and screw connector
B into connect A tightly.
Connector A
Connector B
FOR SCREW-SHAPED TAP
Connect the inlet
1
hose to the water tap
by screwing the con-
nector D tightly.
Rubber
Packing
Connector D
Inlet Hose
Connector C
Loosen the four
2
screws at the water
tap adapter, but don't
loosen the screws until
they are separated from
the water tap adapter.
Connect the inlet
5
hose to the water tap
adapter by puling down
the collar of the hose end.
Connect the connec-
2
tor-inlet supplied if
necessary.
Connector
Inlet
Rubber
Packing
Connector D
Hose
Connector C
Connect the water tap
3
adapter to the water tap tight-
en the four screws evenly
while pushing up the adapter
so that the rubber packing
can stick to the water tap
tightly.
Connect the inlet hose adapter
6
of the hose to the water inlet of
the washer by turning it clock-
wise to be fixed tightly.
• Please check the rubber packing
inside the inlet hose adapter of
the hose.
Insert the inlet hose adapter
3
into the water inlet of a washer
and turn it to be fixed.
• Check the packing in the inlet
CONNECTION
TAPE
5