What To Do If; Troubleshooting - IKEA RAFFINERAD RUTINERAD Owner's Manual

ENGLISH
Clean the glass panels with water and
soap. Dry the glass panels carefully.
Installing the door and the glass panels
When the cleaning is completed, install the
glass panels and the oven door. Do the
above steps in the opposite sequence.
Make sure that you put the glass panels
back in the correct sequence. The second
panel has a decorative frame. The screen-
printing zone must face the inner side of the
door. Make sure that after the installation
the surface of the glass panel frame on the
screen-printing zones is not rough when you
touch it.

What to do if...

Warning! Refer to the Safety chapters.
Problem
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven lamp does not op-
erate.
The display shows an error
code.
Steam and condensation
collect on the food and in
the oven.
Make sure that you install the top panel in
the seats correctly (refer to the illustration).
Possible cause
The appliance is deactiva-
ted.
The clock is not set.
The necessary settings are
not set.
The automatic switch-off is
on.
The fuse in the fuse box is
released.
The oven lamp is defective.
There is an electronic fault.
You left the dish in the oven
for too long.
Remedy
Activate the appliance.
Set the clock. Refer to "Set-
ting the time of day".
Make sure that the settings
are correct.
Refer to "Automatic switch-
off".
Do a check of the fuse. If the
fuse is released more than
one time, contact a qualified
electrician.
Replace the oven lamp.
1. Deactivate the appli-
ance with the house
fuse or the safety switch
in the fuse box and acti-
vate it again.
2. If the display shows the
error code again, con-
tact the service centre.
Do not keep the dishes in
the oven for longer than 15
- 20 minutes after the cook-
ing ends.
16