Aiwa SIMPLE-2 XH-AG1000 HR Service Manual page 8

4. Remove the 20 screws (Cx18, Dx2) and remove the
CABI, REAR ASSY.
C
D
CABI, REAR
ASSY
C
C
C
C
5. Remove the 6 FFCs from the PWB, CONNECT.
6. Remove the PANEL, REAR CD.
PANEL, REAR CD
C
D
C
C
C C
C
PWB, CONNECT
7. Remove the CHAS, 3CD together with the AZG-1.
C
C
C
C
C
C
8. Remove the 2 screws and remove the AZG-1 from the
CHAS, 3CD.
CD service position
The AZG-1 can be repaired while the power is on by using the
jig introduced in the Service Technical Information (SI-98-028).
1. Procedure
Connect the jig as shown below.
– 8 –
CHAS, 3CD
AZG-1
CHAS, 3CD