Opening The Housing; Installing The Camera - Ikelite 6170.30 Instruction Manual

Opening the Housing

Lid Snaps have a Lock.
To open housing, push Lid Snap
Lock forward and lift as shown.
Keep pressure on the Lid Snap so it
does not fly open quickly.
Some Lid Snaps have a lot of
spring tension once they go over
center, so keep a firm grip on the Lid Snap.
Lid Snaps may be opened one at a time.

Installing the Camera

1. Pull out on the top housing controls until they stop. This will get the
controls out of the way for installation of the camera.
2. Remove the back from the housing.
3. Remove camera lanyard from camera if attached.
3. The mounting tray for the camera is secured to the housing back.
Position the camera on the tray.
4. Using a coin or screwdriver (preferred), secure the camera with the tray
mounting bolt which threads into the camera's tripod socket - Diagram A.
CAUTION:
Some camera tripod
socket threads are
plastic. The mounting
bolt is metal. Do not
cross thread or over
tighten as you may
damage the camera
tripod socket threads.
Push Forward
Lift
Lumix
Tray Mounting Bolt
Diagram A
20x
HD
FULL
Lid Snap Lock
L
7