Kero-World KW-24G Owner's Manual page 11

7. Remove the four wing nuts
which hold the
Assembly to the heater and
carefully lift the Wick
Assembly from the heater.
1O. Remove the Wick while
folding it to the inside.
Remove the Wick Sleeve
together with the Wick.
NOTE : DO NOT DISASSEMBLE THE STAINLESS STEEL WICK HOLDER.
13. While pressing each of the
three pins of the Wick
(attached to the
sleeve) toward the inside,
insert the three Pins into
the slanted grooves of the
Wick Guide. Press on each
of the three pins, inserting
them securely in the holes.
8. Replace the Wick Adjustment Knob temporarily.
Wick Turn the Knob CLOCKWISE to raise the Wick.
9. While still holding the Wick
Assembly up-side-down, grasp
the Wick Cover firmly and
PULL it off with a sharp tug.
C A U T I O N : The inside of Wick
cover has sharp teeth. The use
of work gloves is suggested to
avoid injury.
11. Reinstall a new wick and
insert the 3 pins on a new
Wick into the 3 holes on
the Wick Sleeve in the
upward direction.
(See the marked "up" on
the Wick Sleeve.)
NOTE : Turn the Wick adjustment Knob and check that the Wick
moves up and down.
Wick
14. The Wick height will automatically be set to the correct burning
height of 3/8" (10mm).
NOTE : Be sure to check Wick height it should be 3/8" (10mm).
Hole
Pin
RIM OF
WICK
ADJUSTER
(holder)
10
NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
12. Push the new Wick into the
retainer teeth of the Wick
Sleeve so that the wick
adheres tightly around the
inside of the Wick sleeve
so that it is not loose
anywhere.
7/32 in. (5.5mm) All around
WICK 25/64 IN. (10 mm)
Wick
Cover