Kero-World KW-24G Owner's Manual

Kero-World KW-24G Owner's Manual

Portable kerosene-heater

Advertisement

KEROSENE-HEATER
"OWNER'S MANUAL"
Before the first use of this heater, please read this OWNER'S MANUAL very
carefully. This OWNER'S MANUAL has been designed to instruct you as to the
proper manner in which to assemble the heater, maintain the heater, store the
heater, and most importantly, how to operate the heater in a safe and efficient
manner, please keep this manual for future reference.
4221 - 0017- 01
05/04 Rev. 02
PO R TAB LE
Kero-World
MODEL:
KW - 24G
WORLD MARKETING OF AMERICA,INC.
RT. 22 WEST, P.O. BOX 192
MILL CREEK,PA 17060
®

Advertisement

Table of Contents
loading

Summary of Contents for Kero-World KW-24G

  • Page 1 WORLD MARKETING OF AMERICA,INC. RT. 22 WEST, P.O. BOX 192 MILL CREEK,PA 17060 4221 - 0017- 01 05/04 Rev.
  • Page 2: Cautions-Safety Guide

    NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! CAUTIONS - SAFETY GUIDE - TO MANUFACTURER’S INSTRUCTIONS MAY WARNING!! RISK OF EXPLOSION / RISK OF FIRE RESULT IN CONDITIONS WHICH CAN PRODUCE use any fuel other than water-clear 1-K ! NEVER BODILY INJURY AND/OR PROPERTY DAMAGE. kerosene.
  • Page 3: Table Of Contents

    NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! CONTENTS OF OWNER'S MANUAL ITEM PAGE ITEM PAGE CAUTIONS-SAFETY GUIDE ¢ CARBON REMOVAL / DRY BURNING ¢ INTRODUCTION ¢ WICK ASSEMBLY ¢ FEATURES 9~11 ¢æ WICK REPLACEMENT ¢Ł UNPACKING AND ASSEMBLY ¢ EXTINGUISHING THE HEATER ¢Ø...
  • Page 4: Ł Unpacking And Assembly

    NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! ¢Ł UNPACKING AND ASSEMBLY CAUTION: "RISK OF BURNS" DO NOT OPERATE HEATER WITHOUT INSTALLING THE PROTECTIVE GUARD OR GRILLE. 1. REMOVE THE HEATER AND ALL PACKING MATERIALS FROM THE BOX.(Fig. 2) NOTE : Save the shipping carton and packing materials for future storage.
  • Page 5: Ø Kerosene (1-K Only)

    NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! D) INSTALLING CARRYING HANDLE:(Fig. 6) Insert the carrying handle into the holes on the cabinet by aligning holes on brackets of top plate. E) INSTALLING TOP GUARD:(Fig. 7) •Align the 2 brackets on the top guard with the 2 mounting Fig.6 brackets on the front and rear guards.
  • Page 6: Œ Fueling Your Heater

    NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! It is normal for a kerosene heater to give off a slight odor upon start-up and shut-down. After 5-10 minutes of operation, the heater should have reached its normal operating temperature and any odor should be very slight.
  • Page 7: º Automatic Ignition System

    NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! ¢º AUTOMATIC IGNITION SYSTEM For safety and convenience, this heater features an automatic ignition system. 2 "C" cell NONALKALINE batteries, included with the heater, provide the power for the igniter which lights the wick once it has been raised to its maximum height. To use the automatic ignition system: ¡' Make sure the batteries have been installed.
  • Page 8: Checking The Ignition System

    NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! ¢ CHECKING THE IGNITION SYSTEM If the automatic ignition system fails to operate properly, perform the following checks: Igniter BATTERIES -2 "C" cell batteries are located at the rear of the heater. Replace with new NONALKALINE batteries. Fig.15 IGNITER PLUG - If the automatic ignition system still doesn't work after replacing the batteries, check the igniter plug.
  • Page 9: Wick Maintenance

    NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NOTE : During start-up, small adjustments to the flame can be performed by using the burner knob on the front of the burner and MOVING THE BURNER FROM SIDE TO SIDE until the flame at the top of burner is as even as possible.
  • Page 10: Wick Assembly

    NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! ¢ WICK ASSEMBLY- Check at least once a month!! The burner assembly sits on top of the wick guide. Over time, tar deposits can accumulate on the wick guide, and this can prevent the burner assemby from seating properly.
  • Page 11 NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! 7. Remove the four wing nuts 8. Replace the Wick Adjustment Knob temporarily. which hold Wick Turn the Knob CLOCKWISE to raise the Wick. Assembly to the heater and carefully lift the Wick Assembly from the heater.
  • Page 12 NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! 15.Turn the Wick Assembly upside down to replace the Wick Cover. 16. Align the tabs on the wick cover with the four screw holes on the Bottom of the Assembly, as shown, and snap it into place.
  • Page 13: Extinguishing The Heater

    NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! ¢ EXTINGUISHING THE HEATER To extinguish the heater, push down on the manual shut-off knob(Fig. 18) with one hand while holding the wick adjuster knob in the other hand. You will feel the pressure of spring action attempting to turn the wick adjuster knob in a counter- clockwise direction in your hand.
  • Page 14: Long Term Storage Of Your Heater

    NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! TESTING THE SAFETY SHUT-OFF DEVICE : At least once a week during the heating season, it is important to test the safety shut-off device to be sure that it is operating properly. WITH THE HEATER TURNED OFF, raise the wick using the wick adjuster knob to the fully raised position.
  • Page 15: I Trouble Shooting Guide

    NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! ¢ı TROUBLE SHOOTING GUIDE TROUBLE CORRECTIVE ACTION Heater Will Not Light ; 1. Fuel tank is empty 1. Fill tank with water-clear 1-K kerosene. 2. Drain tank. Remove wick assembly & replace wick. 2.
  • Page 16: Parts List

    DRAFT TUBE TOP FUEL GAUGE 08-4897 FUEL GAUGE GASKET TANK ASS'Y 08-4005 IGNITER ASS'Y 08-2495 ¢ł SPECIFICATIONS Model No. KW-24G Type of Heater Convection Heat Output Max. 23,000 BTU/hr Fuel Tank Integral Tank Capacity 1.9 U.S. gallons Continuous Combustion Time Approx.

Table of Contents