Table of Contents
Advertisement
OPERATING
INSTRUCTIONS
Using
the Washer
at a Glance
4. Change
the wash time by pressing
the TIME
ADJUST pad - • to decrease time or • to increase
Operating the washer can be as simple as touching one
time.
cycle pad. The pre-programmed
wash cycles automati-
cally provide warm water washes, cold water rinses and
5. Select other desired options by pressing the appro-
extra large water levels,
priate pads.
However, cycles can also be changed to fit load varia-
Please read the following detailed instructions on how
tions. They can even be programmed
for customized
to best use this washer.
care of special wash loads.
Select Wash Cycle Program
After adding proper laundry additives and placing the
load in the wash tub:
Pre-Programmed
Cycles
For REGULAR
FABRIC
loads, press the REGU-
1. Press a wash cycle program pad. (When a pad is
LAR FABRICS pad. After a slight pause, the washer
properly pressed, an audible tone will be heard and a
will fill and automatically select an Extra Large Water
red indicator will light.) A warm water wash and cold
Level, Warm Wash/Cold Rinse and 10 minutes of agi-
rinse in a full tub of water is automatically provided,
tation. "Wash 10 Minutes" will appear in the Monitor.
If these are appropriate for the load, there is no need
(To change these options see the following section.)
to make any other selections.
Use this cycle for everything
washable
except
If a previous load has not been removed, the washer
permanent
press, delieates
and woolens.
will not acknowledge the cycle selection. The word
For PERMANENT
PRESS loads, press the PERM.
"lid" will appear in the Monitor. To continue, the lid
PRESS pad. After a slight pause, the washer will f_ll
must be raised and lowered and the wash cycle re-
and automatically select an Extra Large Water Level,
selected.
Warm Wash/Cold
Rinse and 8 minutes of agitation.
Cycle selection can be changed while the washer is
"Wash 8 Minutes" will appear in the Monitor. (To
filling by pressing another cycle pad. After the fill is
change these options see the following section.) Use
complete the cycIe cannot be changed,
this cycle for permanent
press items and synthet-
If the pre-progranamed
options are not appropriate for
ies (nylon, polyester,
acrylic, ere.). This cycle auto-
matically provides a cool down rinse to minimize wrin-
the load:
kling when hot or energy-saver hot wash temperatures
2. Change
the wash temperature
by pressing
the
are used.
WASH TEMP ADJUST pad.
For KNIT and DELICATE
loads, press the KNITS/
3. Change
the load size by pressing
the WATER
DELICATES
pad. After aslightpause,
the washerwilI
LEVEL ADJUST pad.
fill and automatically
select an Extra Large Water
NOTE:
If you experience
problems
selecting
the correct
water temperature,
or cycle, or starting
the
washer, reler to page 9 for additional
information
before calling for service.
PAGE 4
Advertisement
Table of Contents
