Front Panel Description; Installation - Keltron LC Series User Manual

Front Panel Description

Figure 1 1 1 1 Keltron LC series front panel Figure Figure Figure Keltron LC series front panel Keltron LC series front panel Keltron LC series front panel
LEDS: LEDS: LEDS: LEDS:
PWR (Green) PWR When lit when power is ON
PWR PWR
DTR/EOP (Yellow) When lit printer is ON-LINE DTR/EOP
DTR/EOP DTR/EOP
When flashing printer is OUT OF PAPER
Function Keys: Function Keys: Function Keys: Function Keys:
ON ON ON- - - - LINE: ON LINE: LINE: LINE:
<SLCT> <SLCT> Press to change printer from ON-LINE to OFF-LINE mode.
<SLCT> <SLCT>
ON-LINE the DTR/EOP LED is ON
<ADVN> <ADVN> <ADVN> <ADVN> Press when printer is ON-LINE to advance paper five lines.
<TEST> <TEST> <TEST> <TEST> Press to print program version, time, date and count value of printer.
<FEED> <FEED> <FEED> <FEED> Press to advance paper one line.
OFF OFF- - - - LINE: OFF OFF LINE: LINE: LINE:
<SLCT> <SLCT> Press to change printer from ON-LINE to OFF-LINE mode.
<SLCT> <SLCT>
OFF-LINE the DTR/EOP LED is OFF
<ADVN> <ADVN> Press when printer is OFF-LINE to enter printer set mode menus.
<ADVN> <ADVN>
See the 'Front Panel Programming' section
<TEST> <TEST> <TEST> <TEST> Press to print program version, time, date and count value of printer.
<FEED> <FEED> <FEED> <FEED> Press to advance paper one line.

Installation

The Keltron LC series printer should be installed in a location that does not exceed the maximum operating
temperature and provides good air circulation. Placing the printer near devices that generate excessive heat
should be avoided.
When cleaning the front bezel use only a soft cloth and neutral soap products. DO NOT use solvents.
Continuous exposure to direct sunlight may accelerate the aging process of the bezel. DO NOT use tools of
any kind (screwdrivers, pens, pencils, etc...) to operate the push buttons on the unit.
Desk Top Mounting: Desk Top Mounting: Desk Top Mounting: Desk Top Mounting:
If mounting the Keltron LC series printer on a desk top it is suggested you install rubber feet (available with
a peel off backing). This will prevent the unit from drifting on the surface during print mode.
4