Table of Contents
Advertisement
Step 2: Install the New Ethernet Cable
1. Insert the new Ethernet cable through the sealing nut, claw, seal, and cable
gland of the back cover.
2. Attach the RJ-45 connector to the Ethernet cable. See
Ethernet Cable
3. Assemble the seal and claw, and then connect the RJ-45 connector to the
Ethernet port inside the camera.
4. Attach the back cover by tightening the three (3) screws.
NOTE:
Make sure the rubber ring on the cover is secured and the screws are
completely tightened to avoid possible water leak.
Hardware Manual
on page 34 for more information.
2
21
How to Make an
1
Advertisement
Table of Contents
