Soundcast OUTCAST JUNIOR Owner's Manual page 6

AC / DC operation (recommended for indoors only)
Plug AC power cord into power supply.
Plug DC connector from power supply into Outcast Junior.
Plug AC power cord into wall outlet.
12 volt automotive power
Plug 12 volt automotive power cable into auto's 12 volt
outlet and the DC connector into the Outcast Junior.
12 volt automotive power adapter
AC power cord plugs into AC / DC power supply
Playing Music on the Outcast Junior
Outcast Junior will play music from two different input sources.
1. Wireless playback from a Soundcast transmitter.
2. Wired playback from the auxiliary input connector located on the Outcast Junior.
Wireless playback from a Soundcast Transmitter
To setup a transmitter, refer to manual supplied with the Soundcast transmitter.
Note that each Soundcast transmitter will have a channel selector switch (channel 1, 2 or 3). You
will need to set Outcast Junior's channel selector switch to the same channel as the transmitter.
The Outcast Junior channel selector is located under the rubber cover located on the top left side
of the unit. The rubber cover is labeled "Aux in" and "Channel 1 2 3". Open the cover by grabbing
the small tab on the bottom of the cover. Gently pull upward, not outward. The cover is secured to
unit so take care not to pull the cover off of the unit. Once the cover is in the up position, select
the proper channel switch setting to match the transmitter.
Rubber cover tab
Channel select switch
6
Lift the rubber cover
to connect either the
AC/DC power supply
or the 12 volt adapter