Thank you for purchasing the CZ-810 Massage chair. Before using your massage chair, please read the content of this instruction manual and refer to it when needed. Table of Contents Luxury Features ………………………......…… 2 Safety Precautions ………………………......…. 3-7 Chair Components ……………………….....….. 8-9 Chair Installation &...
Luxury Features ● The operation of massage chair is controlled by a microcomputer that performs various intelligent massage methods and combinations, like Kneading, Tapping, Clapping, Shiatsu, Rolling, Vibration and Air Massage. All these methods massage acupressure points accurately to effectively alleviate fatigue, promote metabolism and improve blood circulation.
Safety Precautions IMPORTANT SAFETY INSTRUCTIONS When using the massage chair, basic precautions should always be followed, including the following: Read all instructions before using this massage chair. DANGER -To reduce the risk of electric shock: ● Always unplug this massage chair from the electrical outlet immediately after using and before cleaning.
Page 5
● To disconnect, turn all controls to the off position, then remove the plug from the outlet. ● Do not stand on or in the massage chair. Use only while seated. ● The product is not intended for use by children or persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the product by a person responsible for their safety.
Page 6
Caution ● This massage chair is to be used indoors only. ● If you use the massage chair in a cold room, do not increase the room temperature abruptly. It is recommended that you increase the temperature gradually to a normal level. ●...
Page 7
3. People with Medical Conditions Consult your doctor before use if you: ● are under medical rest as ordered by a doctor. ● have spinal disorders, an abnormal spinal condition or have suffered a spinal injury. ● have back problems. ●...
Page 8
4. Instances When the Massage Chair Should Not Be Used In the following events, please switch off the main power switch immediately and disconnect the power cord from the electrical outlet: ● If water is accidentally spilled onto the massage chair. This may result in electric shock or malfunction.
Chair Components Pillow Pad Shoulder Air Bags Controller Backrest Armrest Air Bags Backrest Armrest Seat Pad Side Panel Calvesrest Wheet Legrest Footrest...
Chair Installation & Moving 1. When positioning the chair, please leave 80cm of space behind the backrest to allow free reclining of the backrest. 2. Unplug from outlet when installing the chair parts. Step 1: Take out below objects from 2 cartons. A: Chair Backrest and Seatrest part B: Chair Side panels Step 2: Insert and connect the backrest to the bottom seat, and fasten the backrest into...
Page 12
Step 3: Attach the connecting rod and the u stay fork of the reclining actuator with the flat head rivet, and secure with a split pin as demonstrated in PIC I and PIC 2. A: Connecting Rod ( On the backrest ) B: U stay fork of reclining actuator ( on the seat ) C: Flat head rivet D: Split pin...
Page 13
Step 6: Shoulder part Installation 1) Lock M6-screw onto Backrest by Round Spaner 2) Plug up screw hole with special plug head after well-connect shoulder part. Step 7: Side Panel Installation 1) Fix the side panels to the frame by the two “Z”...
Page 14
Step 8: Connet the cover to the backrest with zipper. Step 9: Clip joint the pillow to the backrest cover. step 8 step 9 Step 10: Connect the wire plug. The back massage strength-control pad has been inserted into the backseat cover. If strong massage is desired, remove the back massage strength-control pad from the cover;...
Page 15
Chair Moving 1. Lift up the Calves Rest. 2. Then recline the chair to approximately to 45 degrees, so that you can easily move the chair around the house with a slight pull push. Note: a. Before you move the chair, please put the footrest back into the original position first. Otherwise, injuries might occur in the process of moving.
Operation Guide Connect to the power supply, and turn the switch to “I” position. The chair is now in idle mode. During idle mode, there are only seven funtions: ON/OFF, Foot Extend, Pause, Recline, Sit Up, Lift Leg or Recline Leg that can be operated. CONTROL BUTTONS FOR THE MASSAGE CHAIR 1.
Page 18
6/7. Length Adjustment Control Button for Legrest - These two control buttons can adjust the length on the legrest. - Press the button once to adjust the legrest to a comfortable length. Press the button again to confirm the length. 8.
Page 19
A. Full Body Auto Programme - If one of the five Auto Programmes is activated before the Auto Scan of the entire body, the machine will automatically do a height scan for the back. At the same time the user can manually adjust the massage height to the prefered level.
Page 20
23. Clapping Clapping function Start/Stop Control Button- 3 sizes of width, 5 levels of speed to be adjusted. - Press this button once to active the clapping function for a full back massage at medium speed. - Press the button again to stop the clapping massage function. 24.
Page 21
30. Strength The Adjustment Button for Kneading Speed After activating the Kneading function, every time the button is pressed, the speed can be adjusted in the cycle. D. The spot or partial back massage 31. Spot The Spot or Localised Back massage. This button allows user to select Spot massage for any part on the back.
Page 22
E. Air-pressure for whole body 36. Neck Air Massage Neck Air Squeeze function Start/Stop Button- 5 levels of intensity to be adjusted. - Press once to activate pre-programmed Air-pressure Massage Mode to enjoy rhythmic air-pressure massage. - Press again to stop the function. 37.
Grounding Instructions This product must be grounded. If it should malfunction or break down, grounding provides a path of least resistance for the electric current to reduce the risk of electric shock. This product is equipped with a cord with an equipment-grounding conductor and a grounding plug.
Chair Specification Description Specification Model No. CZ-810 Rated Voltage 110 - 120 ~ Rated Frequency 50/60 Hz Rated Power Consumption 250W Max Timer 5/10/15/20/25/30 minutes Max time rate 60 minutes Packing size(Seat part): 52.4”x30.3”x37.2” Dimension(L x W x H) Packing size(Backrest part): 35.4”x35.4”x14.2”...
1. Make sure the chair is plugged into a massage chair are not functioning. working outlet. 2. Turn the power OFF and then ON again. If you continue to have problems, please read te warranty card and contact the COZZIA service department.
Product Care and Storage 1. Storing the Massage Chair ● Wipe off dust and dirty from the massage chair with a dry, soft, clean cloth after use. ● Keep the massage chair clean and away from places of high humidity. ●...
Page 27
COZZIA customer service will not issue Return Material Authorizations (RMAs) for products. COZZIA products will be either repaired by the consumer or by an in-home technician. COZZIA will not issue Return Material Authorizations (RMAs) for buyer’s remorse.
Page 28
● The warranty only applies to COZZIA products and does not include any accessories or enhancements. ● Field service requires pre-approval and must be performed by COZZIA’s authorized field service personnel.
Page 29
● COZZIA’s sole liability and the purchaser's exclusive remedy shall be for the repair, or at COZZIA’s option, for the replacement of the defective part. Not withstanding the above, if replacements parts for defective materials are not available, COZZIA reserves the right to make substitutions in lieu of repair or replacement.
Product Serial No. (located on product): Purchase Price: Model No: Date Purchased: First Name: Last Name: Address: City: State: Zip: Phone: Email: Please mail to: Cozzia USA LLC 1102 John Reed Court City of Industry, CA, 91745 Tel: 1-877-977-0656 Fax: 1-800-521-4712...
Need help?
Do you have a question about the CZ-810 and is the answer not in the manual?
Questions and answers