Clock Alarms - NexxTech Wireless thermometer User Manual

Clock Alarms

SETTING THE WEEKDAY (W) AND SINGLE DAY (S)
ALARMS
• Press the ALARM button once to enter the alarm setting
mode. The default alarm is a Weekday alarm (W). The
abbreviation "OFF" with a letter "W" next to it will be
displayed, if the alarm has not been previously set.
• Press and hold the ALARM button for two seconds.
The hour digit will flash.
• Adjust the hour using UP ( ) or DOWN ( ) buttons.
• Press the ALARM button again. The minute digits will flash.
• Adjust the minutes using UP ( ) or DOWN ( ) buttons.
• Press the ALARM button again to confirm and the weekday
alarm time will be set.
• Set Single (S) day alarm if desired in the same manner.
SETTING THE ICE WARNING ALARM (PRE-AL)
If Weekday (W) or Single day (S) alarm is set, the Ice Warning
(PRE-AL) alarm can be programmed.
• Press the ALARM button once to enter into the Ice Warning
alarm setting mode. The abbreviation "OFF" with a "PRE-AL"
next to it will be displayed.
• Press and hold the ALARM button for two seconds. The
number 30 will flash, which indicates that if selected, the alarm
will sound 30 minutes earlier than the Weekday or Single
alarm.
• Select the desired Ice Warning alarm interval in 15 minutes
increments between 15 and 90 minutes, using the UP ( ) or
DOWN ( ) buttons.
• Press ALARM button to confirm and exit from the alarm
setting mode.
ACTIVATING THE ALARM
• Press the ALARM button once to enter the desired alarm
mode.
• Press UP ( ) to activate or DOWN ( ) to deactivate desired
alarm. When alarms are activated, the corresponding icons
W, S or PRE-AL will be displayed.
15