Atomic Clock
Immediately after establishing communication between
the main unit and remote sensor, the atomic time signal
receiver will open and start to search for the atomic time
signal. The search usually takes between 5-8 minutes.
NOTE: Do not press any buttons on the main unit
during auto search as it may interrupt the search and
you will need to start the set up procedure again.
Once the atomic time signal is received, the date and time
will be set automatically, and the [
] icon will appear.
NOTE: It is necessary to set your Time Zone. Keep in
mind that the default zone is a US Pacific Standard
Time (PST). (Refer to the Manual Settings section).
If the time signal has not been received within 8 minutes,
you may use the MODE button to set the time and date
manually. (Refer to the Manual Settings section).
If the clock is set manually, place the unit by the window for
better reception. The atomic clock receiver is automatically
programmed to search for the atomic time signal daily for
every hour between 1:00 am and 4:30 am.
Once the time signal has been successfully received, the
time and date will be updated automatically.
Time and Calendar Display Modes
The clock time has two display modes -
in hour-minutes-seconds format or
in hour-minutes-day format.
The date is displayed in month-date format.
13