Rodgers Topper Owner's Manual page 7

Notice the layout of ·the "Tone Array Panel." The ·"Tone
Array Panel" will hereafter be abbreviated TAP. Your first
step is to turn the organ "on". Look in the upper right
hand corner of the TAP and turn the switch marked "Power"
down to the "on" position. Next, double check the position
of the switch labeled "Console Speakers". This switch must
be in the "on" position to allow the organ to
~ound
thrqugh
~ts
self-contained speaker system (likewise the "External
Speaker" swi tch must .be in the
11
on" posi tion if there are
external tone cabinets that you wish to sound).
Now your "TOPPER" is ready to play. You will notice
that the stop name is constantly illuminated and there is
a small transluscent square located directly above each
stop. If this small square is lit, the stop directly below
is on; if the light is off, the stop is off.
--NOTE: The only time these small lights will not respond
to the TAP is when any of the five presets are engaged and
the STOPRAIL ON piston is not illuminated. (See section on
Presets.)
There are gold colored pads on the top and bottom of
each stop. These are the ~asily activat~d stop switches.
-4-