Table of Contents
Advertisement
* Set "ALARM/MOTION RECORD" mode and then select "PRE-RECORD:
ON". The system will record 100 images in the hard disk before alarm was
activated.
F Press
key to exit menu or press
seconds to exit.
8. System Setup Operation
A. Press
key to enter menu selection mode.
B. Use
/
key to highlight.
C. Press
key to enter highlighted section.
SYSTEM SETUP:
ALARM IN
PASSWORD
PTZ
AUDIO
DISPLAY
DIALER/GPS
DVR ID
FACTORY DEFAULT
UPDATE CODE FROM HDD
a. Alarm In: To set Alarm functions
ALARM IN
ALARM IN1
ALARM IN2
ALARM IN3
ALARM IN4
* Normal Close: The signal loop is closed under normal conditions. When the loop
becomes open, alarm will be triggered until the loop becomes closed again. In
other words, if the loop keeps on open for a period of time, alarm will keep on
triggering in that time interval.
* Normal Open: The signal loop is open under normal conditions. When the loop
becomes closed, alarm will be triggered until the loop becomes open again. In
other words, if the loop keeps on closed for a period of time, alarm will keep on
triggering in that time interval. For patrol cars, 2 alarms are generally used: A
manual switch, and 1 for when emergency lights are activated.
key and hold more than 2
ALARM IN1
ALARM IN
RE-ACTION
ALARM OUT :OFF (or ON)
20
:NORMAL CLOSE
(CH01~04)
:CH01
Advertisement
Table of Contents
