I.link (Ieee1394); Precautions - Toshiba Satellite M200 User Manual

Optional Devices

i.LINK (IEEE1394)

i.LINK (IEEE1394) is used for high-speed data transfer for a range of compatible
devices such as
1. Digital video cameras
2. Hard disk drives
3. MO drives
4. CD-RW drives
CAUTION: i.LINK uses a four-pin connector, which does not carry
electric current. External devices will need their own power supply.

Precautions

1. Make a back-up of your data before transferring it to the computer. There is
a possibility that the original data will be damaged. There is a particular risk
that some frames will be deleted in the case of digital video transfer.
TOSHIBA assumes no liability for such loss of data.
2. Do not transfer data in areas where static electricity is easily generated or in
areas subjected to electronic noise. Data can be destroyed.
3. If you are transferring data through an IEEE1394 hub, do not connect or
disconnect other devices from the hub during data transfer. There is likeli-
hood that data will be damaged. Connect all devices to the hub before you
turn on the computer's power.
4. You may not use any copyrighted video or music data copied from a video
camera except for your personal enjoyment.
5. If you connect/disconnect an i.LINK device to/from another i.LINK device
that is currently exchanging data with the computer, data frames might be
dropped.
6. Make sure data transfer has ended or turn off the computer, before you:
a. Connect/disconnect an i.LINK device to/from the computer.
b. Connect/disconnect an i.LINK device to/from another i.LINK device
that is connected to the computer.
8-14 User's Manual