Step 6 : Reprogramming The Remote Control; Smart Eco-Sensor - Panasonic DMP-BDT320 Operating Instructions Manual

STEP 6 : Reprogramming
the remote control
If you have more than one Panasonic player/
recorder and the remote control operates both
products at once, you will need to change the
remote control code to prevent this occurrence.
( 35, "Remote Control")
16
VQT3V87

Smart eco-sensor

This mode will decrease the power consumption
when the unit is in standby mode and the sensor
does not detect people close by.
Preparation
Set "Quick Start" to "On (Smart eco-sensor)"
( 35).
Sensor detection range image and operation
of the unit
A Sensor detection range (at i20eC) :
Within a distance of approx. 5 m and an
angle of 20e up and down and 30e left and
right from the unit
≥ The power consumption is minimal when
people are out of the detection range for
more than 30 minutes.
≥ The following will occur when there is a
movement within the detection range, such
as someone walking into the room where
this unit is placed.
– Speed of startup from the standby mode
will increase.
– Idle power consumption will increase.
(About the power consumption
B The slot-in LED will light up when there is a
movement in immediate proximity of this unit,
such as inserting a disc.
≥ This function does not work under the following
conditions.
– For about 1 minute after connecting the AC mains lead.
– The unit is placed in a glass-fronted cabinet.
≥ The detection sensitivity may be reduced under the
following conditions.
– The room temperature is close to the body temperature.
– The unit is exposed to direct sunlight or close to heating
appliances.
– People are approaching straight to the unit.
– Other than listed above, temperature change or some
interference, etc., can affect the detection sensitivity.
43)