Table of Contents
Advertisement
Use up and down keys to highlight individual sensor input, and use left or right keys to select the
condition of alarm output. Type of sensor input, can be NO (normally open) or NC (normally close).
☞ Default setting by factory "ON"
1.3-4Alarm Out Period
Under this item, the screen prompt is as follows:
〔Alarm Period〕
30 sec
01 min
03 min
10 min
Manual off
This alarm time item, is to configure the alarm output activation duration on associated alarm being
triggered. If "continuous" is selected, then the alarm output will be activated forever until manual
de-activation of the alarm output is being conducted.
Operator can highlight the value and press "Enter" to select.
1.3-5Manual de-activation of alarm output(Alarm Manual off)
Under this item, alarm output can be deactivated by pressing "Enter".
1.4Network
Under this item, the screen prompt is as follows:
IP Setup
Network Password
1.4-1Static internet protocol
After selecting "IP Setup", the screen prompt will be changed as follows:
Static IP
Dynamic IP
Operator can select the desired IP status, by using up or down key, followed by "Enter".
26
Advertisement
Table of Contents
