Advertisement
Pilot Lamp
Electrode
Holder
Connection
Torch Connection
Pilot Lamp
Function
Switch
Torch Connection
Torch 2-pin Socket
1. Connection of the Input Cables
Connect this welding & cutting equipment with power supply of 220V AC.
Connect the earth terminal with the earth cable of minimum diameter of
2
2.5mm
.
2. Connection of the Output Cables
2a. Install welding/cutting torch according to the drawing.
2b. Connect the one-knob connector and air plug to the corresponding
connector on the panel board. Then fasten the screw.
2c. Plug the air plug of the back cable to in the clockwise direction. Connect
INSTALLATION
Main Current
Power Lamp
Function
Switch
Torch 2-pin Socket
CT-312
Main Current
Power Lamp
Power Switch
Ground Connection
CT-213
Power Switch
Ground
Connection
Argon Gas Inlet
Argon Gas Inlet
Compress Air Gas
Regulator
Compress Air Gas
Inlet
Compress Air Gas
Regulator
Compress Air Gas
Inlet
7
Advertisement
