Related Manuals for Hong Kong Easyweld EasyCT 213
Summary of Contents for Hong Kong Easyweld EasyCT 213
- Page 1 EasyWeld EasyCT 213/312 Multipurpose Tig / Plasma Cutter Operation Manual Hong Kong EasyWeld Limited...
- Page 2 $75! The EasyCT 213/312 uses special safety redundant circuitry with built in auto-protection and self adjusting circuitry to keep your machine running in a safe threshold.
-
Page 3: Table Of Contents
CONTENTS - Warning - General Description - Main Parameter - Installation - Operation - Caution - Maintenance - Troubleshooting... -
Page 4: Warning
WARNING Welding and cutting is dangerous to the operator, people in or near the working area, and the surrounding, if the equipment is not correctly operated. Therefore, the performance of welding/cutting must only be under the strict and comprehensive observance of all relevant safety regulations. Please read and understand this instruction manual carefully before the installation and operation. -
Page 5: General Description
EasyCT 213/312 is a welding & cutting equipment of two functions: TIG and CUTTING. During the operation of TIG welding, this welding & cutting equipment is featured with the stability of output. -
Page 6: Main Parameter
MAIN PARAMETER TYPE EasyCT 312 EasyCT 213 Input Voltage (VAC) 220±15% 220±15% Input Frequency (Hz) 50/60 50/60 Consumption (KVA) No-load Loss (W) Duty Cycle (%) Power Factor 0.93 0.93 Efficiency (%) Insulation Class Protection Class 1P21 1P21 Weight (Kg) Size(mm) 395 ×... -
Page 7: Installation
INSTALLATION Main Current Compress Air Gas Power Switch Pilot Lamp Inlet Power Lamp Function Switch Ground Connection Electrode Holder Connection Argon Gas Inlet Torch 2-pin Socket Compress Air Gas Torch Connection Regulator CT-312 Main Current Pilot Lamp Power Lamp Power Switch Function Switch Torch Connection... - Page 8 earth clamp with work piece. 2d. The electrode holder cable should normally be connected to the positive terminal, while the work piece should be connected to the negative terminal. 3. Power Supply Switch In case that power switch is on, built-in fan start work and current meter displays the current value.
-
Page 9: Operation
OPERATION 1. TIG Welding Function 1) While this welding & cutting equipment is operated, power supply indicator is on, and the built-in fan is functioning. 2) Opt the TIG welding function mode. 3) Press the gas-releasing button, and modulate the volume of gas output to the required value. -
Page 10: Maintenance
environment should be maintained within -10°C to +40°C. 1.3 Keep this welding & cutting equipment 30cm distant from the wall. 1.4 Keep the working environment in good ventilation. 2. Safety tips 2.1 Ventilation This welding & cutting equipment is small-sized, compact in structure and of excellent performance in current output. - Page 11 and compensate it if necessary. 2. While this welding & 1. Possible misconnection with input of 380V, and cutting equipment is occurrence of over voltage protection status. operated, the pilot Reconnect with input of 220V, and restart. lamp is on, no output, 2.
- Page 12 4. Components of HF arc starting circuit are possibly damaged. Check and replace them if necessary. 6. While this welding & 1. It is possible of over-current protection status. cutting equipment is Switch off the power supply, wait till the fault operated, the fault indicator is off, and restart this welding indicator is on, and...