Configuration - Honeywell IP Receiver User Manual

Configuration

After you log in the system, you can see the following page. The system includes three
functional tabs, which are Configuration, Search, and Reports. On the top-right corner of
the page, you can select "Change password" or "Log out", below which is the current version.
The "Network configuration" page shows the corresponding IP address, subnet mask, and
gateway of the two network adapters. Change the parameters in the textboxes and click Run
to save them, as shown in the following figure.
If the IP address is incomplete or has a value greater than "255", the
Note
system will prompt the error information.
Figure 5-4 Configuration
Figure 5-5 Configuration Successful
Honeywell
29