Network Structure Of Ip Receiver And Configuration On Router - Honeywell IP Receiver User Manual

6 Network Structure of IP Receiver and
Configuration on Router
Alarms from WAN devices are transmitted to the IP Receiver that is connected to the LAN by
router, so it's a must to configure router to assure the safe and effective alarm report of IP
Receiver (refer to the following configuration steps that are performed on a BELKIN router).
1. Open the configuration page of the router by entering the IP address
http://192.168.0.1
2. Disable DHCP server: DHCP server assigns IP address automatically, which
might cause IP Receiver to be assigned dynamic IP address and fails to
receive the alarms.
The configuration page of DHCP is displayed as follows.
3. Set the virtual server to receive the alarms from WAN. The ports to be set
include TCP-7838, TCP-4001, and TCP-4002. Enable these ports so that IP
Receiver can receive the alarms from WAN.
The configuration page of virtual server is displayed as follows.
in IE.
Figure 6-1 DHCP Setting
Honeywell
33