Toyota Supra 1997 Owner's Manual page 19

Hide thumbs Also See for Supra 1997:
Table of Contents

Advertisement

SETTING THE SYSTEM
1. Turn the ignition key to the "LOCK"
position and remove it.
2. Have all passengers get out of the ve-
hicle.
3. Close and lock all the side doors, back
door and hood.
The indicator light will come on when all
the sidedoors, back door and hood are
closed and locked.
As the side doors are locked, the system,
will give you a preparation time of 30 sec-
onds before the setting, during which the
side doors, back door and hood may be
opened to prepare for the setting.
14
Be careful not to use the key when open-
ing any side door. This will cancel the sys-
tem.
4. After making sure the indicator light
starts flashing, you may leave the ve-
hicle.
The system will automatically be set after
the preparation time passes. The indica-
tor light will flash to show the system is
set. If any of the side doors, back door or
hood is open at that time, the setting is in-
terrupted until it is closed and locked.
Never leave anyone in the vehicle when
you set the system, because unlocking
from the inside will activate the system.
WHEN THE SYSTEM IS SET
Activating the system
The system will give the alarm and cut the
starter circuit under the following condi-
tions:
R If any of the side doors, back door or
hood is unlocked without using the
key.
R If the battery terminal is disconnected
and then reconnected
After one minute, the alarm will automati-
cally stop with the starter cirucit cut kep-
ton.
Reactivating the alarm
Once set, the system automatically resets
the alarm each time all the side doors,
back door and hood are closed after the
alarm stops.
The alarm will be activated again under
the following conditiions:
R If any of the side doors, back door or
hood is opened
R If the battery terminal is disconnected
and then reconnected
Stopping the alarm
Turn the ignition key from the "LOCK" to
"ACC" position . The alarm will be stopped
with the starter circuit cut kept on. Stop-
ping the alarm in this manner will keep the
alarm from being reactivated when any of
theside doors, back door or hood is
opened.
Interrupting the setting
When the system set, the back door can
be opened by using the key without set-
ting off the system. While the back door is
open, the setting is interrupted and the
side doors and hood may be opened in
addition. However, when the battery ter-
minal is disconnected and then recon-
nected, the system is activated.

Advertisement

Table of Contents
loading

Table of Contents