Honda 2010 Ridgeline Technology Reference Manual page 10

HomeLink ®
(if equipped)
The HomeLink Universal Transceiver built into your vehicle can be programmed to operate up to three
remote-controlled devices around your home, such as garage doors, lighting, or home security systems.
Training a Button
1
Position the remote transmitter you
wish to link 1–3 inches from the
HomeLink button you want to program.
2
Press and hold the desired
HomeLink button and the button on
the remote transmitter.
Does the HomeLink indicator (LED) blink at a
faster rate after about 10 seconds?
NO
a
Press and hold the button on the
remote transmitter and the HomeLink
button at the same time. Then, while
continuing to hold the HomeLink button,
press and release the button on the
remote transmitter every 2 seconds.
Does the LED blink at a faster rate within 20
seconds?
NO
3 Press and hold the programmed
HomeLink button for about a
second.
Does the device (garage door opener) work?
NO
4
Press and hold
the HomeLink
button again.
HomeLink indicator
HomeLink LED
YES
flashes for 2 seconds,
remains on.
then remains on.
a
The remote has a rolling code.
Press the "learn" button on the
remote-controlled device (e.g.,
garage door opener).
b
Within 30 seconds, press and
hold the programmed HomeLink
YES
button for 2 seconds.
5
Press the programmed HomeLink
button again; the remote-controlled
device should operate.
2010 Ridgeline
Retraining a Button
1
Press and hold the desired
HomeLink button until the HomeLink
indicator begins to flash slowly.
YES
Indicator remains
on for about 25
Training
seconds (standard
complete
transmitter).
2
When the indicator begins to flash
slowly, continue to hold the
HomeLink button and follow steps
1– 4 under Training a Button.
Erasing Codes
To erase codes stored in all buttons,
press and hold the two outer buttons
until the HomeLink indicator begins to
flash (about 10 to 20 seconds), then
release the buttons.
If you sell the vehicle, make sure to
erase all codes.
If you have any problems programming
HomeLink, see the owner's manual included with
the device you are trying to program, call
HomeLink at (800) 355-3515 or visit
www.homelink.com.
Indicator flashes rapidly
for 2 seconds, then
remains on for about 23
seconds (rolling code
transmitter).