Using The Surface Units - GE JCB909 Owner's Manual And Installation Instructions

Using the surface units.

Be sure you turn the control knob to
OFF when you finish cooking.
8
How to Set
Push the knob in and turn in either
direction to the setting you want.
At both OFF and HI the control clicks
into position. You may hear slight clicking
sounds during cooking, indicating the
control is keeping the power level you set.
A HOT SURFACE indicator light, on
the cooktop, will glow when any radiant
element is turned on. It will remain
on until the surface is cooled to
approximately 65.5°C (150°F).
Hot surface indicator light will:
I
come on when the unit is hot to the touch.
I
stay on even after the unit is turned off.
I
glow until the unit is cooled to approximately
65.5°C (150°F).
Using the Bridge Burner
To use the bridge burner, turn the
left front control knob clockwise to the
BRIDGE BURNER settings.
For full bridge surface unit operation,
also turn on the left rear surface unit.
To use only the front surface unit, turn
the control knob counterclockwise to the
FRONT BURNER settings.
Dual Surface Unit Control Knob
The right front surface unit has 2 cooking sizes
[9 " and 12 "]) to select from
(22.9 cm and 30.5 cm
so you can match the size of the unit to the size
of the cookware you are using.
To use the small surface unit, turn the
control knob counterclockwise to the
SMALL BURNER settings.
To use the large surface unit, turn the
control knob clockwise to the LARGE
BURNER settings.
WARNING:
units are automatically disabled during
the self-clean cycle. Make sure that all
surface unit controls are turned off at all
times during the self-clean cycle. Any
surface unit that is set to an on position,
while the self-clean cycle is operating, will
automatically come on after the self-clean
cycle is finished, and could result in an
on, unattended surface unit. Wait until
the self-clean cycle is finished to set and
use the surface units.
(on some models)
(on some models)
The surface
30.5 cm
(12")
22.9 cm
(9")