Table of Contents
Advertisement
Using the Travel Charger
Important! Verify that the handset battery is installed prior to
connection. If the battery is not properly installed
and the wall charger is connected, the handset may
power off and on continuously, preventing proper
operation.
1. Plug the small end of the Travel Charger into the Power/
Accessory Interface connector.
2. Plug the other end into a standard AC wall outlet.
3. When charging is finished, remove the flat end from the
interface connector jack on the phone.
Warning! A touch screen responds best to a light touch from the
pad of your finger. Using excessive force or a metallic
object when pressing on the touch screen may
damage the tempered glass surface and void the
warranty. For more information, refer to "Standard
Limited Warranty" on page 175.
Note: Failure to unplug the wall charger before you remove the
battery, can cause damage to the phone.
Low Battery Indicator
When the battery is weak and only a few minutes of talk time
remain, the battery icon (
warning tone at regular intervals. In this condition, your phone
conserves its remaining battery power, not by turning off the
backlight, but by entering the dimming mode. For a quick
check of your battery level, glance at the battery charge
indicator located in the upper-right corner of your device's
display. Solid colour (
) indicates a full charge.
) blinks and the device sounds a
Getting Started
5
Advertisement
Table of Contents
