Problem Analysis And Solutions - 2GOability Boost User Manual

Because your batteries may only have a partial charge when you first receive your
scooter, you may not experience full riding time until you have fully charged them.
Your scooter is equipped with either an off-board charger. To ensure maximum life
charge your batteries as described below:
Turn off the power of the scooter;

Slide away the cover of the battery receiver socket and insert the battery charger

socket;
Do not switch on the battery charger until all the plugs are in position;

The led light of the battery will be amber while charging;

The led light will turn green when the batteries are fully charged;

If you are not going to use the scooter for more than a week, fully charge the

batteries and then disconnect them from the scooter.
8

PROBLEM ANALYSIS AND SOLUTIONS

Your 2GOability Boost scooter is inspected and adjusted so that you can use it
immediately.
Number of flashes
1
2
3
4
5
6
7
8
9
10
Picture 19
Meaning
Battery needs recharging
Battery voltage is too low
Battery voltage is too high
Current limit time out
Brake fault
Not in neutral at power up
Speed pot error
Motor volts error
Other internal error
Controller over heat
25