Buderus GB162 User Instructions page 7

– Do not store any flammable material or
liquids in the immediate vicinity of the
boiler.
– Never use chlorinated detergents or
halogenated hydrocarbons (e.g. in
spraycans, solvents and detergents,
paints, adhesives) in the room where the
boiler is installed.
– When Calcium Chloride is present in
concrete floors (when poured in winter) it is
necessary to seal the floor with a suitable
paint.
– Do not allow too much dust to collect on the
device.
– Do not use the boiler if any part has been
under water. Immediately call a trained
service technician to inspect the boiler and
to replace any part of the control system
and any gas control which has been under
water.
http://www.buderus.net
– Should overheating occur or the gas supply
fails to shut off, do not turn off or disconnect
the electrical supply to the pump. Instead,
shut off the gas supply at a location
external to the boiler.
– The venting system must be inspected
annually. Replace any parts which show
deterioration from corrosion or any other
sources.
– This boiler does not have a pilot. It has an
ignition device which automatically lights
the burner.
– Check for smell of gas around the boiler
area. Be sure to smell next to the floor
because propane gas is heavier than air
and will settle on the floor.
– Use only your hand to turn the gas control
knob (fig. 4 on page 18). Never use tools. If
the knob will not turn by hand, don't try to
For your safety
7