Section 3:Operating Instructions; System Components - OTS Aquacom MK2-DCI User Manual

SECTION 3: OPERATING INSTRUCTIONS
3.1

SYSTEM COMPONENTS

See Figure 1 for a panel description.
1) Record Out:
2) Volume:
3) Power ON:
4) Battery Level:
5) Ext. Power:
6) Push-to-talk:
7) Tender Headset: Tender-worn earphones connect via banana plug connec-
8) Mic. (RED):
9) Volume:
10) Earphone:
11) Microphone:
12) Volume:
13) Microphone:
14) Earphone:
15) Handle:
16) Volume:
17) Volume:
18) Speaker:
19) Thumb Screw:
20) Speaker:
21) Volume:
22) Speaker:
23) Cross Talk:
Permits tender to record diving operations (Line level).
Tender-to-diver(s) volume control.
Turns the power ON or OFF.
Color LEDs illuminate to alert tender to conditions of
batteries.
A 12-volt, DC power source can be used.
Push button used in two-wire mode by tender to talk to
divers.
tors.
Used for hand-held or boom mic. via banana plug con-
nector.
Diver #1 diver-to-tender volume control.
Diver #1 earphone connection (banana or bare-wire style).
Diver #1 microphone connection (banana or bare-wire
style).
Diver #1 tender-to-diver volume control.
Diver #2 microphone connection (banana or bare-wire
style).
Diver #2 microphone connection (banana or bare-wire
style).
Front panel handle (right & left side).
Diver #2 tender-to-diver volume control.
Diver #2 diver-to-tender volume control.
Front-panel speaker.
One of four front panel screws (captive).
Remote speaker output (speaker level).
Volume control for front panel speaker.
Switch to turn the front panel speaker ON or OFF.
Switch used to cross-talk Diver 1 to Diver 2 or vice versa.
Tender must hold the switch in the direction of the cross
3