Table of Contents
Advertisement
Controller Setup
Note: the system's controller ID, source assignments and room names
should be readily available for controller and source setup.
Select "Controller Setup" from the Main menu under "System."
1.
Select the controller type for your specific configuration.
2.
Enter unique zone names for each zone in use. Leave zone names
blank for unassigned zones to prevent them from showing up on
the Zone List page of the user interface.
3.
Click Save Changes.
Controller Type
Choose appropriate
Zone Names
Enter names - No duplicates
Must be clicked to save information
Save Changes (Not shown)
Russound TCH1 Installation Manual
Source Setup
1.
Enter a source name and source type for each source. If the
source does not support RNET, the source type should be set to
"Standard IR."
2.
When a source input is not being used, leave the source name blank
and select 'None' in the corresponding source type combo box.
3.
Click Save Changes.
Source Name
Enter appropriate
No duplicates
Source Type
Choose appropriate -
enter "Standard IR" for
non-RNET sources
CONFIGURATION
Save Changes
Must be clicked to save
information
11
Advertisement
Table of Contents
