Setting And Checking Via Ivr - SunComm SC-375 User Manual

17. Setting and checking via IVR

User could get or set some parameters of the system by dialing in the
mobile numbers of the device.
voice response system.
only Mobile light flash), you could dial its mobile numbers. When you
hear the dial tone, press the following codes to set or check the device.
Item Function
1 Reboot
2 Factory Reset
3 Check IP Address #120#
4 Check IP Type
5 Check Network
Mask
6 Check
IP Address
7 Check Primary
DNS Server
8 Check Firmware
Version
9 Set as
client
10 Set Static IP
Address
11 Set Network Mask #113xxx*xx Must set Static IP first.
In the first 20 seconds after power-on (when
Code
#195#
#198#
#121#
#123#
Gateway #124#
#125#
#128#
DHCP #111#
#112xxx*xx
x*xxx*xxx#
The status or result is reported via
Reboot the device
Return to default settings
IVR announces the current IP
address. Default: 192.168.0.100
IVR announces DHCP is on or off.
Default: off
IVR announces the current network
mask. Default: 255.255.255.0
IVR announces the current gateway
IP address. Default: 192.168.0.254
IVR announces the current setting in
the Primary DNS field.
Default: 192.168.0.1
IVR announces the version of the
firmware.
The system is changed to DHCP
Client type
DHCP is disable and system is
changed to static IP type.
Enter IP address using numbers on
the telephone keypad. Use the *
(star) key when entering a decimal
point.
-36-
Action