Installation; Installing Batteries In The Telephone; Connecting The Phone; Wall Mounting - NexxTech CALLER ID User Manual

Installation

Installing Batteries In The Telephone

Warning
The telephone can be operated with or without AC adapter. The full
range of telephone functions can only be utilized if batteries or the
power adapter (optional) are used.
The battery compartment is located on the base of the telephone. Open
the battery compartment and insert 4 x AA batteries (not included). Pay
attention to correct polarity. Close the battery compartment cover.
When the batteries are weak, the icon
Replace the batteries.
1. Use a flat-blade screwdriver or the tip of a pen to lift and remove the
battery compartment door.
2. Insert four AA batteries into the compartment as indicated by the
polarity symbols.
3. Snap the battery compartment door back into place.
Connecting The Telephone
1. Connect the AC adapter (optional, not supplied) to the DC 9V 200mA
jack at the top end of the telephone and a standard AC outlet.
2. Plug one end of the telephone cable supplied into the TEL LINE jack
at the back of the telephone base.
3. Plug the other end of the telephone cable into the wall outlet.
4. Plug one end of the curly cord into the socket on the handset.
5. Plug the other end of the curly cord into the left side of the telephone.
appears in the display.

Wall Mounting

Method A

To fit to an existing telephone wall plate with modular connector simply:
1. Lift out the handset tab holder on the base of the unit. Rotate it 180°,
and snap it into place (fig. A) so it will hold the handset in place when
the phone is mounted on the wall.
2. Insert the mounting bracket's two tabs into the matching slots on the
phone's base (fig. B).
3. Then press down and slide the bracket upward until the tabs snap
into place.
4. Plug the short telephone line cord (supplied) into the base of the
phone and plug the other end into the telephone wall plate socket.
5. Position the mounting holes on the base of the phone over the two
protruding screws on the wall plate. Gently push the phone flush
against the wall plate then slide the phone downwards locking it into
place.
fig. A

Method B

Attach directly to a wall:
1. Drill two holes vertically, one above the other, 83mm apart, and leave
the screws protruding from the wall by 5mm.
2. Follow steps 1 and 2 above.
3. Then press down and slide the bracket upward until the tabs snap
into place.
4. Plug one end of the telephone cable into the TEL LINE jack at the
back of the base.
5. Plug the other end of the telephone cable into the telephone socket,
then align the base's keyhole slots with the screws and slide the
phone downward to secure it.
4
fig. B