Getting to know your appliance
The instruction manual is the same for various different hobs.
An overview of the models with their dimensions is given on
page 2.
The control panel
Controls
When you touch a symbol, the respective function is activated.
The hotplates
Hotplate
Single-circuit hotplate
$
Dual-circuit hotplate
ð
When the hotplate is activated: the corresponding indicator lights up.
When the hotplate is switched on: the last selected size is automatically selected again
Residual heat indicator
The hob has a residual heat indicator for each hotplate.
Setting the hob
This section informs you how to set the hotplates. The table
shows heat settings and cooking times for various meals.
Switching the hob on and off
The main switch is used to switch the hob on and off.
To switch on: touch the
%
next to the main switch and the
ready for use.
To switch off: touch the
%
main switch and the display go out. All hotplates are switched
off. The residual heat indicator remains on until the hotplates
have cooled down sufficiently.
Note: The hob switches off automatically if all hotplates have
been switched off for more than 20 seconds.
&RQWURO IRU
KRWSODWH VHOHFWLRQ
&RQWURO IRU
PDLQ VZLWFK
Activating and deactivating
Touch the
symbol. A signal sounds. The lamp
displays light up. The hob is
‹
symbol until the lamp next to the
'LVSOD\V IRU
KHDW VHWWLQJ³É
UHVLGXDO KHDW
RSHUDWLQJ UHDGLQHVV ¯
&RQWUROV IRU
KHDW VHWWLQJ DGMXVWPHQW
ð
symbol
If
appears in the display the hob is still hot. It may be used,
•
for example, to keep a small meal warm or to melt cooking
chocolate. The display remains lit until the hotplate has cooled
sufficiently.
Setting a hotplate
Use the + and - symbols to set the desired heat setting.
Heat setting 1 = lowest setting
Heat setting 9 = highest setting
There is an intermediate setting between each heat setting. This
is identified by a dot.
&RQWUROV IRU
Í GXDOFLUFXLW KRWSODWH
' FKLOGSURRI ORFN
5