Hugyfot
Strobe Connections
The Hugyfot strobe connections are integrated in the leakage detector
circuit board. This circuit board runs on a single 3.6 Volt 1/2 AA Lithium
battery. The main parts of this system are described as below.
External strobe connection
Nikonos 5-pin or S6-pin
A
TTL Converter
F
Standard setup .
External strobe connection(s) A is (are) connected to D and/or E on leakage detector. Hotshoe B is connected to
C on leakage detector. X is used for firmware upload.
Setup with TTL converter .
External strobe connection(s) A is (are joined and) connected to D on leakage detector. Connection E on leakage
detector is joined with connection F on TTL converter. Hotshoe B is connected to H on TTL converter. G is power
supply on TTL converter.
In case you run out of batteries, a backup system is provided. TTL control will no longer be available!
Backup for standard setup .
External strobe connection(s) A is (are) connected to J and/or K on backup circuit board. Hotshoe B is connected
to I on backup circuit board.
Backup for setup with TTL converter .
External strobe connection(s) A is (are joined and) connected to J or K on leakage detector. Hotshoe B is con-
nected to I on backup circuit board.
Hugyfot Housing for
Internal camera hotshoe
Nikon or Canon
B
Backup
G
H
Canon 450D
Hugyfot leakage warner with integrated
strobe connections Nikon or Canon
I
+
J
Battery holder for
K
3.6 V 1/2AA Lithium battery
10
C
D
E
X
-
User manual