Table of Contents
Advertisement
PLAYING USB
Press the "CD/USB" button to switch to CD / USB playback.
NOTE: If in FM mode ,please press CD/FM first to switch to CD mode before switch to USB.
Connecting a USB device
1) Insert a USB key inside the connector.
2) Press the CD / USB key to start.
Remark: Depending on the capacity of the device, the reading can take more than 1 minute.
The unit cannot read my USB device.
-
Once you have plugged your device to the unit, you may need to switch on the USB device
before it can operate.
-
This unit does not support a direct USB connection with a computer. You need to use a USB
device, a MP3 player or a PMP (Portable Multimedia Player with hard disk).
-
If you are using a USB external hard disk: you need to connect your device simultaneously to
an external power source and to the unit. If you are using a self-powered PMP, make sure that
the battery is sufficiently loaded.
-
Check that the files system of your USB device is formatted into the FAT or FAT 32 format. USB
device formatted into NTFS are not compatible with this unit. Caution: if you attempt to modify
your file system, formatting your device will erase all data. Please refer to your USB device's
instruction manual first.
-
Warning: Connect your USB device directly to the USB port of the device. Using an extension
cable is not recommended and may cause interference and failure of data transfer
USING HEADPHONE
Inserting the plug of your headphone into the Headphone socket (on the front panel). It will
enable you to listen to the audio in private.
Note: 1. Avoid impairing your hearing, please turn the volume to the lowest status before
listening.
2. When plugging the headphone, the speakers have no sound.
Remark: Headphone is not provided.
FM RADIO OPERATION
1. Enter FM Function
In the turn-on or playing status, press the CD/FM button on the remote control (or front panel) to
enter FM status. Press this button again to switch between FM and CD playing.
2. Select Bands
1) Select band by pressing SEEK- or SEEK+ button: under some frequency, press the button, the
frequency will be up or down on the step. The step of FM is 0.05 MHz
2) Select band by pressing number buttons: you may select the bands that have been saved by
11
Advertisement
Table of Contents
