Table of Contents
Advertisement
6. Basic operation
❖ Be sure to set up by both PC Viewer and the car.
Parking mode of auto only works properly after setup is completely done by both PC Viewer and the car. Insert microSD card into
the computer and run PC Viewer. Open microSD card and go to configuration. Choose [Auto] in parking mode and click [Save].
Take out microSD card and insert it into the device. After installing the device in the car, turn on the device and car and set up the
device, according to voice guidance.
❖ Be sure to turn off all other devices before checking voltage measurement.
After turning on the car, be sure to turn off all other devices like light, audio, air conditioner, heater, etc in order to check exact
voltage measurement. After that, press "
❖ Switching time to parking mode may vary depending on the battery status of car.
Switching time to parking mode is 20 minutes after the car turned off. However, it may vary depending on the battery status of the
car.
❖ If the car does not support [Voltage Sensing] due to the battery status, it automatically switches to [Vibration Sensing].
❖ Need to set up parking mode of auto again for the following.
1. In case of installing the device in other car.
2. In case of changing power supply such as battery, generator, etc.
Manual recording
A. Starting manual recording
► Short press "
" for manual recording, then LED2 turns to red color and manual recording starts.
► One file is max. 20 sec (before 10 sec & after 10 sec based on button press).
NOTE
❖ Manual recording is not working during event recording.
❖ Event recording is not working during manual recording.
22
R700
" and turn off the car and press "
" to finish the setup.
Advertisement
Table of Contents
