Pool Maintenance And Chemicals; Common Pool Problems - Intex Oval Frame Pool User Manual

POOL MAINTENANCE & CHEMICALS
REMEMBER TO
• Protect all pool occupants from possible water-related illnesses by keeping the
pool water clean. Do not swallow the pool water. Always practice good hygiene.
• Keep your pool clean and clear. The pool floor must be visible at all times from
the outside barrier of the pool.
• Keep children away from pool covers to avoid entanglement, drowning, or other
serious injury.
The maintenance of a proper water balance is the single most important factor in
maximizing the life and appearance of the liner as well as ensuring clean, healthy and
safe water. Proper technique is important for water testing. See your pool professional
for chemical, test kits and testing procedures. Be sure to read and follow the written
instructions from the chemical manufacturer.
1. Never let chlorine come in contact with the liner if it is not completely dissolved. Dissolve
granular or tablet chlorine first in a bucket of water, Then add it to the pool water. Likewise,
with liquid chlorine; mix it immediately and thoroughly with the pool water.
2. Never mix chemicals together. Add the chemicals to pool water separately. Thoroughly
dissolve each chemical before adding another one to the water.
3. An Intex pool skimmer and an Intex pool vacuum are available to assist in maintaining
clean pool water. See your pool dealer for these pool accessories.
4. Do not use a pressure washer to clean the pool.
PROBLEM
ALGAE • Greenish water.
• Green or black spots
• Pool liner is slippery
COLORED • Water turns blue,
WATER
FLOATING • Water is cloudy or
MATTER IN
WATER
CHRONIC LOW • Level is lower than
WATER LEVEL
SEDIMENT ON • Dirt or sand on pool
POOL BOTTOM
SURFACE DEBRIS • Leaves, insects etc.
SAVE THESE INSTRUCTIONS
WARNING
TROUBLESHOOTING
DESCRIPTION
• Chlorine and pH level
need adjustment.
on pool liner.
and/or has a bad odor.
• Copper, iron or
brown, or black when manganese in water
first treated with being oxidized by the
chlorine. added chlorine.
Common.
• "Hard water" caused by a
milky. too high pH level.
• Chlorine content is low.
• Foreign matter in water.
• Rip or hole in pool liner
on previous day. or hoses.
• Heavy use, getting in
floor. and out of pool.
• Pool too close to trees.
(88PO) OVAL FRAME POOL ENGLISH 7.5" X 10.3" PANTONE 295U
CAUSE SOLUTION
• Super chlorinate with shock
treatment. Correct pH to your
pool store's recommended level.
• Vacuum pool bottom.
• Maintain proper chlorine level.
• Adjust pH to recommended
level.
• Run filter until water is clear.
• Replace cartridge frequently.
• Correct the pH level. Check with
your pool dealer for advice.
• Check for proper chlorine level.
• Clean or replace your filter.
• Repair with patch kit.
• Finger tighten all caps.
• Replace the hoses.
• Use Intex pool vacuum to
clean bottom of pool.
• Use Intex pool skimmer.
11/08/2010
English
88PO
Page 13