Table of Contents
Advertisement
Wireless remote controller kit
11
HOW TO PERFORM EMERGENCY
OPERATION
In the event of an emergency shown below, push emergency operationeon the signal
receiving unit (inside the ceiling panel) for emergency operation.
• The batteries of the remote controller have been exhausted.
• The remote controller is out of order.
• The remote controller has been lost.
1
Start
Push emergency operation.
(When the emergency operation is started at a room temperature of 75°F (24°C) or more, the air
conditioner enters the cooling mode. When the emergency operation is started at a room
temperature below 75°F (24°C), the air conditioner enters the heating mode.)
2
Stop
Push emergency operation once again.
• When the emergency operation does not work, confirm that all the bits of DIP switch
S003 on the P.C. board of the receiver unit are set OFF. If any of these bits are set ON,
turn them all OFF.
15-EN
CAUTION
– 15 –
Owner's Manual
1
2
Advertisement
Table of Contents
