Menu Items - Samsung 670 Installation Manual

Menu Items

¦
To Enter this menu: Press the
To exit from this menu : Power Off (or Power Off and unplug if you have changed SI Vendor), and then turn on again. Any
changes you made are saved.
Menu
Hospitality
Hospitality Mode
Mode
SI Vendor SI Vendor
Power On Channel Last Saved
Power On Channel
Power On Channel
Power On Volume
Power On
Power On Volume
Min Volume
Max Volume
Power On Source
Power On Option
Channel Setup
Channel Editor
Channel
Dynamic SI
[HC670_677_678-ZA]Install Guide-X0ENG.indd 19
→ → → → ENTERE buttons in order.
MUTE 1 1 9
Item initial Value
Select the Hospitality mode.
Standalone y Standalone mode: TV works alone, without an SI STB or SBB
y Interactive mode: TV works with an SI STB or SBB
y Interactive mode : Samsung / OCC / MTI / Nstreams / NXTV / Enseo /
OFF
y Stand-alone mode : OFF / Smoovie
Set the default values that will be applied when the TV is turned on.
y User Defined : Lets you set Power On Channel and Channel Type
y Last Saved : If you select this item, when the TV is turned on, it displays
... When the TV is turned on, it switches automatically to this channel.
Num
y Select channel band : AIR (analog air band), DTV (digital air band), CATV
...
Type
y User Defined : Lets you set the Power On Volume manually. See Power
Last Saved
y Last Saved : When the TV is turned on, it returns to the volume that had
... The TV turns on with this Volume Level in Stand Alone Hospitality mode.
Num
The minimum Volume Level the user can set in Stand Alone Hospitality
0
mode.
100 The maximum Volume Level the user in Stand Alone Hospitality mode.
TV Select the input source the TV displays when turns on.
Determines the TV's state when power returns after a power failure or after
you have unplugged the TV and then plugged it in again.
y LAST OPT : Returns to its last Power state. If it was in Stand-by, it
Last Option
y Power On : When the power returns, the TV turns on.
y Standby : When the power returns, the TV enters the Standby mode.
Gives you direct, immediate access to some of the Channel menu functions
on the user Channel menu such as Auto Program, Antenna selection, etc.
The Channel Editor lets you edit the channels stored in the TV's memory.
Using Channel Editor you can:
• Change the channel numbers and names, and sort the channels in your
desired channel number order.
• Apply the video mute to channels you select. The video mute blanks out
the video from a channel and outputs only the sound while displaying a
speaker icon on the screen.
The Channel Editor also lets you view information about each channel easily,
without your having to display each channel directly.
y On : Check the DTV Program channel number. (If Dynamic SI is On, it is
ON
y Off : Does not check the DTV Program channel number. (If Dynamic
Description
Cardinal / Guestek / Seachange / EBL
manually. See Power On Channel and Channel Type below.
the channel it was displaying when it was turned off.
(analog cable band), CDTV (digital cable band)
On Volume below.
been set when the power had been turned off.
returns to Stand-by. If it was on, it turns on.
not availale to edit DTV channels in Channel Editor.)
SI is Off, it is available to edit DTV channels in Channel Editor, but
additional DTV channel program number update is not supported.)
19
English
2014-03-17 10:02:27