Advertisement
When unpacking, check to make all parts listed on Page 4 are included.
If any parts are missing or broken, please call Harbor Freight Tools at the number
on the cover of this manual.
1.
Attach the two Wheel/Brake Assemblies [2] to the Rear Saw Stand [1-2] as
shown in the Assembly Diagram on Page 4. Secure using the hardware
provided with each Assembly. Tighten Bolts fully.
2.
Attach the Saw Stand to the Saw Frame Assembly [4, not included] using
the two Stand Knobs [3] in the location shown in the Diagram. Be sure to
tighten Knobs fully.
3.
Carefully follow the Assembly and Operation Instructions for the 10" Tile
Saw, SKU #95385, which is intended for use with this product. The Tile Saw is
sold separately, and available for purchase through Harbor Freight Tool
Company.
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM
IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER
NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO
THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE
PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE
PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY
STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN
BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER
ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS
OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
SKU 46310
Unpacking
Assembly
PLEASE READ THE FOLLOWING CAREFULLY
Page 3
REV 01/07
Advertisement
